Microsens RS232 Spezifikationen PDF herunterladen (Seite 12)

19'' 6U Chassis page 12/71

Preventive Maintenance

Dust Filter replacement Procedure

The dust filter should be visually examined on a six month basis.

Procedure

• Using a cross head screwdriver loosen the two holding screws on the

frontplate, located at both sides of the FAN front panel (see picture below)

• Replace the dust filter on the FAN front panel

• Put back the FAN front panel

• Using a cross head screwdriver tighten the two holding screws on the

frontplate, located at both sides of the FAN front panel

• Check that the dust filter presence LED is green on the FAN front panel

End procedure

Figure 11: FAN front panel.

Corrective Maintenance

Management Board MGNT

MGNT Replacement Procedure

Use the following procedure to replace a MGNT management board:

Procedure

• Perform a full inventory on the MGNT using the objects:

mgnt2RinvHwPlatform

mgnt2RinvSoftwarePackage

mgnt2RinvGateware

mgnt2RinvAgent

Location: ...\microsens\mgnt2\mgnt2RemoteInventory

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 70 71

Keine Kommentare

Microsens RS232 Spezifikationen Seite 12