Microsens RS232 Spezifikationen PDF herunterladen (Seite 21)

19'' 6U Chassis page 21/71

• Check the inventory to verify type of XFP currently installed. Consult the

object:

ms43062XMRinvXfp

Location: ...\microsens\ moduleMS43062XM\ ms43062XMri\

• Take the necessary steps to minimise the impact on your network, traffic by-

pass re-route etc.

• Disable the line by setting the object:

ms43062XMCtrlXfp1Onoff

Location:

\microsens\moduleMS43062XM\ms43062XMcontrolsWrite\

ms43062XMCtrlxfp1Onoff\

• Remove the Fibre Optic connector

• Release the XFP by: Carefully opening the latch or pressing the locking

button and slide the XFP out of the module and place it aside

• Gently push the XFP into the relevant module port until it is securely seated.

Take care to insert the XFP respecting the orientation described in the

following picture.

Do not remove the protective caps from the XFP until you are ready to attach

the network fibre-optic.

• If Latch-Type XFP; Close the latch to lock it into place

• Clean Fibre Optic connectors on fibre optic cable

• Re-connect Fibre

• Enable port by re-setting the object:

ms43062XMCtrlXfp1Onoff

Location:

..\microsens\moduleMS43062XM\ms43062XMcontrolsWrite\ms43062XMCtrlxfp1O

noff\

• Verify correct operation of the XFP

End procedure

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 70 71

Keine Kommentare

Microsens RS232 Spezifikationen Seite 21