Microsens RS232 Spezifikationen PDF herunterladen (Seite 19)

19'' 6U Chassis page 19/71

• Clean Fibre Optic connectors on fibre optic cable

• Re-connect Fibre

• Verify correct operation of the SFP

End procedure

SFP Replacement Procedure on MS430601M and MS430605M

Each client port has its own LED located on the front panel of the MS module to

indicate operating status of each of the ports. If a client port SFP needs to be replaced

use the following procedure.

Procedure

The SFP ’s are hot-swappable therefore there is no requirement to power down the

Module.

The following procedure describes how replacing an SFP on a MS430601M. Replacing

an SFP on MS430605M is done exactly the same way by simply replacing MS430601M by

MS430605M in the object names.

• Ensure that the correct module is selected for management. Consult the

object:

mgnt2GigmSelectedBoard

Location:

...\microsens\mgnt2\mgnt2SNMPAgentData\mgnt2ModulesManagement\

• Change if necessary

• Refresh the module inventory setting the following object:

ms430601mRinvReloadInventory

Location: ...\microsens\moduleMS430601M\ms430601mri\

• Check the inventory to verify the type of SFP currently installed

Using the table: ms430601mRinvSfpTable

Location: ...\microsens\moduleMS430601M\ms430601mri\ms430601mriTable\

• Take the necessary steps to minimise the impact on your network, traffic by-

pass re-route etc

• Disable the port by setting the object:

ms430601mCtrlclientSfpOnOffCtrlPortn relating to the relevant client

port

ms430601mCtrllineSfpOnOffCtrlPortn relating to the relevant line

port

Location:

...\microsens\moduleMS430601M\ms430601mcontrolsWrite\ms430601mCtrlPort\

ms430601mCtrlclientSfpOnOffCtrlTable\

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 70 71

Keine Kommentare

Microsens RS232 Spezifikationen Seite 19