Microsens RS232 Spezifikationen PDF herunterladen (Seite 42)

19'' 6U Chassis page 42/71

Normal management operations may be carried out during the transfer, however

the response time may be a little slower than usual.

Stage 3 – Monitoring

• Verify that the transfer is taking place by consulting the object:

mgnt2LoadState

downloading(2) indicates transfer is in progress

idle(1) indicates transfer is complete

Location:

..\microsens\mgnt2\mgnt2SoftwareManagement\mgnt2LoadMSTable\mgnt2Load

MSEntry

This object returns the status of the file. At this stage it should be downloading.

• Track progress of the transfer by consulting the object:

mgnt2LoadDownloadProgress

Location:

..\microsens\mgnt2\mgnt2SoftwareManagement\mgnt2LoadMSTable\mgnt2Load

MSEntry

This returns the transfer progress as a percentage.

In the event of an incorrect completion of this phase, or reception of a trap

message, see Fall Back 5 for reverse procedure. (Fall Back Procedures).

In the case of a Gateware transfer or a Software transfer using the Immediate

method the generic slot MS is now upgraded.

• Proceed to Verification

3. Activation Phase

The object of this phase is to switch the new code into service. These operations are to

be carried out only in the case where the Manual method was previously selected.

To activate the new code a reset must take place.

• In the case of a Software change, a Cold or Warm Reset will achieve this,

selecting the bank containing the new Software

• In the case of a Gateware change, a Cold reset is required selecting the bank

containing the new Gateware

All Reset procedures are described in the Software Management section of the

generic slot MS SNMP User Manual.

Verification

Check the upgrade and erase unwanted files.

When the new code is in service perform an inventory check for your records:

• Consult the objects:

msxxxxxxxRinvSwPlatform

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 70 71

Keine Kommentare

Microsens RS232 Spezifikationen Seite 42