Microsens RS232 Spezifikationen PDF herunterladen (Seite 38)

19'' 6U Chassis page 38/71

Associated with the package to be erased.

If the package that you intend to erase from the FLASH is in use, i.e.:

mgnt2ExtractedPack = "two", this operation will have no effect. Erasure of a

package in use in prohibited.

End procedure

Generic slot MS Module Code Update

A user may update the MS Module Code, Software or Gateware, remotely. To achieve

this you will need:

An SNMP V2C browser. (For reading and updating values in the MIB)

A tftp client.

The Module Code update procedure is carried out in three phases:

1. Remote loading of the code via tftp into the MS430502M chassis

2. Transferring to the generic slot MS

3. Activation and Verification of the new code

Described in more detail as follows:

The following procedure is common to all modules type (MS43062XM, MS430601M,

etc…), but some OIDs are module dependant. So in the complete procedure, all the

module OID are referenced using the following notation:

msXXXXXXXDwlSwBank1Notempty

This OID gives the status of the SW bank 1 for the MS43062XM when XXXXXXX is equal

to 43062Xm, for the MS430601M when XXXXXXX is equal to 430601m, etc…

Procedure

1. Remote Loading Phase

The object of this phase is to load the code into the RAM of the MS430502M chassis

MGNT. There are no service implications during this phase.

• Use your SNMP browser to perform a table update and check the status of

the RAM using the table:

• mgnt2LoadMSTable

Location: ...\microsens\mgnt2\mgnt2SoftwareManagement

There is space for one file in the RAM, at this stage in the procedure there

should be none.

• Open a Command Line Interface window from your operating system and go

to the directory where you placed the new code

In the example the file extension is given as .ext. In reality the file extension will

depend on the type of code you are dealing with:

*.srec => Software

*.hexout => Gateware

• Enter the line (Windows XP):

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 70 71

Keine Kommentare

Microsens RS232 Spezifikationen Seite 38